东芝X光机KXO-50S高压系统故障代码表

admin

故障代码	故障现象
1	The battery for memory backup is dead.
2	Abnormality of the XCON 32SF PWB.
3	Filament heating current is greater than the standard value.
4	Filament heating current is less than the standard value.
5	Tube current is greater than the standard value.
6	Tube current is less than the standard value.
7	The anode-side tube voltage is higher than the standard value.
8	The anode-side tube voltage is lower than the standard value.
9	The anode-side tube voltage is higher than the preset value by 30%. Press the power ON switch to reset the system.
10	The anode-side tube voltage is lower than the preset value by 30%. Press the power ON switch to reset the system.
11	The cathode-side tube voltage is higher than the standard value.
12	The cathode-side tube voltage is lower than the standard value.
13	The cathode-side tube voltage is higher than the preset value by 30%.Press the power ON switch to reset the system.
14	The cathode-side tube voltage is lower than the preset value by -30%.Press the power ON switch to reset the system.
15	Tube current time product is greater than the standard value.
17	Overcurrent in the filament heating circuit.
18	Overcurrent in the inverter of the IGBT driver DR1.
19	Overcurrent in the inverter of the IGBT driver DR2.
20	Abnormality CNT1.
24	The X-ray switch is being pressed when the power is turned ON.
26	Abnormality CNT2.
35	The tube voltage is less than 50% of the set value.
40	Coil current is less than the standard value.
41	Abnormality in the inverter drivers of the high-speed starter.

关注我们，若想了解更多，还可通过以下方式关注我们呦

1. 腾讯微博：@

2. 微信官方订阅号：九翔医疗维修

（微信号：）

来稿请发送至mixiucai@163.com